3.3 Borosilicate glass with Al-SS/Cu coating 58x1,800mm with heat pipe
Thickness of glass tube
Vacuum tube tightness
Idle sunning property parameters
Average heat loss coefficient
1.2mm thickness of galvanized steel material,38degree
Structure of tank:
6 holes for PT valve,water inlet and outlet,electric heater,Mag Rod , Temp.Sensor.
Argon arc welding
Made of stainless steel screw
Heat pipe size
Dia14mm x 70mm length condenser,170cm length in total
Heat pipe material
Heat pipe power
from -35C to 250C
Other Tube quantity
Other Tank capacity
Heat pipe pressurized solar water heater features:
1.Adopts the best conduction performance metal- heat pipe (copper). 2.Can be used all year round in the cold climate. 3.High efficiency, rapid warming. Heat pipe in vacuum tube could transfer hot energy to cold water in pressurized solar water heater tank rapidly. 4.The whole pressure of the system is up to 1.5kg/M2, the inlet could connect the tap water directly, the max pressure can be 0.6Mpa. 5.No water in the tube, one tube broken don't influence the system working. 6.The design for inner tank is reasonable and scientific, which could hold 100, 000 times fatigue test without any damage. 7.Dual-purpose brackets for both flat and inclined roof. 8.The system is pressurized, it keep a constant temperature of water in the tank, avoid the problem came from water level controller malfunction which could cause water flow out.
Pressurized solar water heater working principle:
1.The pressurized solar water heater tank has no exhaust hole, therefore, it must bear the pressure came from tap water. The hot water comes out because of water pressure. 2.Vacuum tube absorbs solar energy, and conductive copper pipe transfers the heat into the pressurized solar water heater tank. In this case, the water inside the tank becomes hot. 3.No water in the heat pipe makes the whole system could bear pressure.